How to create separate margin lines for coping and crown on the same tooth in Dental Designer

How to create separate margin lines for coping and crown on the same tooth in Dental Designer

Currently, Dental Designer does not support creating different margin lines for a coping and crown on the same tooth within a single order.

This limitation can present challenges for users who need to design a coping on a half-die and a crown down to the margin line on the same tooth. 

Below is an explanation of the issue and a workaround:

The Issue

When designing a coping and crown on the same tooth in a single order, the margin line is shared between both, which may not be ideal.
 

Workaround

1. Create a new order for the coping only;

2. Design and produce the coping;

3. Install it in the patient's mouth.

4. Re-scan and create a new order for the crown;

5. Proceed with designing the crown. 

For further assistance, please contact us at [email protected]